melanocortin receptor comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2025-12-18. Where a claim depends on a specific study, the study is described rather than over-claimed.
Melanotan II is a synthetic peptide analog modeled on alpha-melanocyte-stimulating hormone, a naturally occurring signaling peptide involved in pigmentation. Its structure is a cyclic heptapeptide containing two non-natural substitutions, norleucine at position four and D-phenylalanine at position seven. These modifications resist enzymatic breakdown and extend the molecule's activity relative to the native hormone. The compound binds melanocortin receptors and is studied mainly as a pharmacological tool rather than a therapeutic product. It has never received approval as a medicine in any major jurisdiction.
The compound was developed in the late 1980s and 1990s by academic researchers investigating photoprotection. The rationale held that stimulating melanin production might reduce ultraviolet damage to skin and lower skin cancer risk. Early work examined receptor binding, pigment response, and short-term tolerability in small studies. That program did not produce an approved drug, and formal development stalled after early-phase trials. Whether induced pigmentation confers meaningful photoprotection remains an open question.
Melanotan II is a synthetic cyclic heptapeptide with the sequence Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, corresponding to a molecular formula of C50H69N15O9 and a monoisotopic mass near 1024 daltons. It was designed as a structural analogue of alpha-melanocyte-stimulating hormone, a peptide hormone produced by cleavage of proopiomelanocortin. A lactam bridge between the aspartate and lysine side chains closes the ring, and the C-terminal amide removes a free carboxyl group. Both modifications increase resistance to enzymatic degradation compared with the linear parent hormone. Four substitutions distinguish it from afamelanotide, the linear analogue studied under the name melanotan I.
Receptor-binding studies classify melanotan II as a non-selective melanocortin agonist. It interacts with MC1R, MC3R, MC4R and MC5R, with reported affinities in the low nanomolar range and no strong subtype preference. Activation of MC1R on dermal melanocytes shifts pigment synthesis toward eumelanin, the dark polymer deposited in melanosomes and transferred to keratinocytes. Because the same peptide engages MC4R in the hypothalamus, it also appears in animal work on food intake and erectile response, which is why it is discussed in both pigment and metabolic research. Which receptor populations dominate after systemic exposure in humans is not fully established.
Published pharmacokinetic information is limited and comes mainly from small studies rather than registrational trials. Plasma half-life is usually described as short, on the order of tens of minutes, followed by rapid tissue distribution and clearance of the intact peptide. Metabolites and low concentrations of parent compound have been reported in urine, a detail relevant to anti-doping and forensic testing. Whether repeated exposure changes receptor sensitivity or clearance over time remains an open question. Values differ noticeably between analytical assays, so published numbers should be read as approximate rather than definitive.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic cyclic heptapeptide | Belongs to the melanocortin agonist family |
| Key substitutions | Nle4 and D-Phe7 | Improve resistance to enzymatic degradation |
| Molecular formula | C50H69N15O9 | Approximately 1024 g/mol |
| Regulatory status | Not approved as a medicine | Distributed as a research chemical |
| Common synonyms | Melanotan II, MT-II, MT-2 | Spelling varies across sources |
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Melanocytes are the pigment-producing cells of the skin, and they carry melanocortin-1 receptors on their surface. When the receptor is activated, cyclic adenosine monophosphate rises inside the cell and raises the activity of enzymes such as tyrosinase, which increases melanin output. Melanotan-2 binds melanocortin-1 receptors in vitro and in animal models, and this binding is generally described as the basis for the tanning effect. Other receptors account for different effects: melanocortin-4 receptors contribute to appetite and erectile signalling, while melanocortin-3 and melanocortin-5 receptors contribute to energy balance and exocrine function.
The most widely used method to determine absolute molar mass is size-exclusion chromatography (SEC) coupled with multi-angle laser light scattering (MALS). SEC can separate macromolecules based on their size by passing an analyte containing molecules of different sizes through a column containing porous substrate. Larger components of the analyte spend less time traveling through these pores and therefore elute faster, while smaller components can access more of these pores and are therefore retained longer. However, molar masses determined through SEC require calibration curves constructed from standards, and calculating absolute molar masses require absolute detection systems. The two primary detection systems used to determine absolute molar mass are light scattering photometers and viscometers. Static light scattering (SLS) experiments measure the difference between the light scattered by a dilute solution and the light scattered through pure solvent. Given a dilute enough solution and at an angle of θ = 0° between the incident light and the scattering direction, this difference, known as the excess Rayleigh ratio ΔR(θ), can be approximately related to the weight-average molar mass Mw through the equation:
The NAD-I riboswitch (also called the nadA motif) was identified in species of the bacterial phylum Acidobacteriota, where it typically resides upstream of nadA genes encoding quinolate synthase, an enzyme in the de novo NAD⁺ biosynthesis pathway. Unusually, despite regulating genes relevant to NAD⁺ metabolism, neither binding domain of the NAD⁺-I riboswitch's dual-aptamer architecture has been shown to specifically recognize the nicotinamide portion of the coenzyme; instead, the RNA robustly binds the adenosine 5′-diphosphate (ADP) moiety of NAD⁺.
ACE inhibitors block the conversion of angiotensin I (ATI) to angiotensin II (ATII). Arteriolar resistance is lowered, venous capacity is increased; cardiac output, cardiac index, stroke work, and volume is lowered; resistance in renal blood vessels is lowered; and lead to increased natriuresis (excretion of sodium in the urine). Bradykinin levels increase because angiotensin-converting enzyme also degrades bradykinin, and its inhibition reduces bradykinin inactivation. Under normal conditions, angiotensin II has these effects:
Sources: en.wikipedia.org
4-Chloromethcathinone (also known as 4-CMC and clephedrone) is a stimulant drug of the cathinone class that has been sold online as a designer drug. 4-CMC produces similar effects to mephedrone, and has been sold as an alternative in countries where mephedrone was scheduled. 4-CMC produces similar side effects to mephedrone, including: increased blood pressure, tachycardia, hyperthermia, and anxiety. Its chemical structure closely resembles para-chloromethamphetamine, raising concerns about its potential to readily induce cell death of serotonergic neurons. However, no neurotoxicity of this kind has been found to occur, but studies involving mice do indicate that it is neurotoxic through other mechanisms, similarly to other cathinones. 4-CMC is cytotoxic and induces oxidative stress, more so than 4-MMC. Moreover, β-keto substitution is thought to change cathinone structure activity relationships (SAR) and metabolism compared to amphetamines, leading to differences in pharmacology.
In recent years, diode array UV-Vis detectors have been increasingly used to collect entire spectra at any given moment of data collection. Diode array detectors (DADs) collect entire UV spectra at every point of the eluting peaks while operating as a multi-wavelength UV-Vis detector. This way they give additional information, which help understand more about the nature of the substances appearing in the chromatogram and allow their identification. DADs are the preferred detectors for HPLC method development because they facilitate better peak identification.
Site-specific recombination makes use of phage integrases instead of restriction enzymes, eliminating the need for having restriction sites in the DNA fragments. Instead, integrases make use of unique attachment (att) sites, and catalyse DNA rearrangement between the target fragment and the destination vector. The Invitrogen Gateway cloning system was invented in the late 1990s and uses two proprietary enzyme mixtures, BP clonase and LR clonase. The BP clonase mix catalyses the recombination between attB and attP sites, generating hybrid attL and attR sites, while the LR clonase mix catalyse the recombination of attL and attR sites to give attB and attP sites. As each enzyme mix recognises only specific att sites, recombination is highly specific and the fragments can be assembled in the desired sequence. Vector design and assembly Because Gateway cloning is a proprietary technology, all Gateway reactions must be carried out with the Gateway kit that is provided by the manufacturer. The reaction can be summarised into two steps. The first step involves assembling the entry clones containing the DNA fragment of interest, while the second step involves inserting this fragment of interest into the destination clone.
Sources: en.wikipedia.org
It is a synthetic cyclic peptide designed as an analog of alpha-melanocyte-stimulating hormone. It acts on melanocortin receptors and is best known from research into pigmentation. It is not an approved pharmaceutical product.
No regulatory agency has approved it for any indication. It is encountered as a research chemical sold outside pharmaceutical supply chains. Products marketed this way are not subject to the manufacturing and labeling requirements that apply to approved drugs.
Reports describe increased skin pigmentation as well as side effects such as nausea, flushing, and changes to existing moles. Much of the evidence comes from small studies and case reports rather than large trials. The long-term safety profile is therefore uncertain.
No. It is a synthetic analogue carrying four amino acid changes, a lactam ring and an amidated C-terminus. The natural hormone is a linear thirteen-amino-acid peptide processed from proopiomelanocortin.